The Mudpuppy 85-2sc: Pick up & clean up to 150 GPM
Do you wish to keep your jobsite clean and save money at the same time?
The MudPuppy is a highly effective drilling mud recirculation system. It is a solid control system and was born out of necessity. Our MudPuppy continues to sell because of its effectiveness in the field. Backed by quality and a warranty. Our partners' Tibban’s MudPuppy will perform around the clock (24 hours a day, 7 days a week, not like other machines on the market) for your drilling project.
The MudPuppy “Recycles the mud and dumps the crud!”
- You can set up the MudPuppy in just a few minutes. No settling pit to dig and fill. Only 450 Gallons of water needed to get started.
- Clean mud means a clean hole. The job site will be clean and dry. Pump, drill string, and swivel all last longer with clean mud.
- Mix only the amount of mud needed to drill the hole.
|Mud Reservoir "Patented"||Total Weight|
|450 Gallons Usable||3,500 Pounds|
|3/16" HR Steel||Foot Print 4' Wide x 8' Long x 5'6" Tall|
4" Suction Outlets
|Sloped walls & Sand traps||25 Gallons Diesel approximately|
|Deutz Diesel 68 HP BF4L2011||20 hours "Run time may vary"|
|Air-Cooled 4 cylinder in-line engine||Desander System|
|Fulfills Tier III EPA emissions regulations||2"x3"x8.5" 118 (Centrifugal) Mud Pump|
|Engine Monitor System (Safety shutdown) Guage Panel||With mechanical seal|
|Read more specifications|
6987 EN Giesbeek
Drop us an email at: firstname.lastname@example.org
or Call us today +31 313 88 02 00
or find a representative email@example.com