Support

MudPuppy MP170-2sc

Share this page

Main information

MudPuppy MP170-2sc

The Mudpuppy MP170-2sc: Pick up & clean up to 350 GPM

Do you wish to keep your jobsite clean and save money at the same time?

The MudPuppy is a highly effective drilling mud recirculation system. It is a solid control system and was born out of necessity. Our MudPuppy continues to sell because of its effectiveness in the field. Backed by quality and a warranty, our partners' Tibban’s MudPuppy will perform around the clock (24 hours a day, 7 days a week, not like other machines on the market) for your drilling project.

The MudPuppy “Recycles the mud and dumps the crud!

  • You can set up the MudPuppy in just a few minutes. No settling pit to dig and fill. Only 600 Gallons of water needed to get started.
  • Clean mud means a clean hole. The job site will be clean and dry. Pump, drill string, and swivel all last longer with clean mud.
  • Mix only the amount of mud needed to drill the hole.

Specification

Mud Reservoir "Patented" Deutz Diesel 75 HP BF4L2011
600 Gallons Air-Cooled
3/16" HR Steel 4 cylinder in-line engine
(2) - 4" Suction Outlets Fulfills Tier III EPA emissions regulations
Sloped walls & Sand traps Electronic Engine Monitor System (Safety shutdown)

 

Alternator 12 Volt
  Shaker
Sand Guzzler (Patented) 3' x 5' Double Screen - Bottom 10 & 100 Top Mesh
10" (Centrifugal) Mud Pump Hydraulic driven w/constant speed control
Can take rocks up to 1 - 1/2" Diameter Rotary Motion
Pump 0 - 3000 RPM Total Weight
0 - 350 GPM 3,900 Pounds
20' of 3" Hose Foot Print 5'6" Wide x 11' Long x 6'6" Tall
Hydraulics System Fuel Capacity
Closed Center 25 Gallons Diesel approximately
Variable Displacement pump 20 hours "Run time may vary"
Load sense Control Desander System
55 Gallon Oil Reservoir 2"x3"x8.5" 118 (Centrifugal) Mud Pump
High Capacity Cooling System With mechanical seal
Mud Mix Hopper Desander Manifold Pressure Gauge
Jet ventury Mud mix system 2-5" Desander Cones
  170 GPM
  15 Micron Cut

Pictures

Eijkelkamp SonicSampDrill
Headquarters
Uitmaat 8
6987 ER Giesbeek
The Netherlands

Drop us an email at: sales@sonicsampdrill.com

or Call us today +31 313 88 02 01

or find a representative sales@sonicsampdrill.com

Subscribe to our newsletter